Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
zprobe [2020/01/01 22:30]
wolfmanjm [BLTouch or servo-retractable touch probe.]
zprobe [2020/02/18 13:03] (current)
wolfmanjm [Usage]
Line 728: Line 728:
 === Usage === Usage
  
-|| <​kbd>​G29</​kbd>​ || test probes in a grid pattern within the size specified producing a map of offsets, this can be imported into a graphing program to visualize the bed. optional ​parameters <kbd>In</​kbd>​ sets the number of points to the value n, <kbd>Xn</​kbd>​ sets the x size for this probeand  <kbd>Yn</​kbd>​ sets the size for this probe.||+|| <​kbd>​G29</​kbd>​ || test probes in a grid pattern within the size specified ​starting at the current head position, ​producing a map of offsets, this can be imported into a graphing program to visualize the bed. Required ​parameters <kbd>Xn</​kbd>​ sets the width for this probeand  ​<kbd>Yn</​kbd>​ sets the length ​for this probe. optional parameters <​kbd>​In</​kbd> ​and <kbd>Jn</​kbd>​ sets the grid size (default is set in config).||
 || <​kbd>​G32</​kbd>​ || probes the grid and turns the compensation on, this will remain in effect until reset or <​kbd>​M561/​M370</​kbd>​ optional parameters <​kbd>​Jn</​kbd>​ sets the radius for this probe.|| || <​kbd>​G32</​kbd>​ || probes the grid and turns the compensation on, this will remain in effect until reset or <​kbd>​M561/​M370</​kbd>​ optional parameters <​kbd>​Jn</​kbd>​ sets the radius for this probe.||
 || <​kbd>​M370</​kbd>​ || clears the grid and turns off compensation (**NOTE** you must home after this) || || <​kbd>​M370</​kbd>​ || clears the grid and turns off compensation (**NOTE** you must home after this) ||