Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
switch [2019/08/07 00:34]
98.191.200.92 [Config definition] Removed nonexistent option
switch [2019/09/28 01:21]
71.231.99.111 [Homing a multi-motor axis.]
Line 370: Line 370:
  
 This was written with the idea you'd have one endstop for each of your motors. However, assuming this is for the Z axis and you have a Z probe, you can use your probe instead of endstops for the multi-motor levelling simply by replacing the G28s with G30s ( see the zprobe documentation ). This was written with the idea you'd have one endstop for each of your motors. However, assuming this is for the Z axis and you have a Z probe, you can use your probe instead of endstops for the multi-motor levelling simply by replacing the G28s with G30s ( see the zprobe documentation ).
 +
 +
 +==== Using a third party branch that supports this feature by default
 +
 +A new branch has been added by a community member to the [[http://​smoothieware.org/​third-party-branches|third party branches]] section called [[https://​github.com/​Smoothieware/​Smoothieware/​pull/​1431|Slave motors and Endstops]] that supports this feature through simple configuration.