Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
supported-g-codes [2019/03/06 17:23]
wolfmanjm
supported-g-codes [2019/03/06 22:25] (current)
wolfmanjm
Line 39: Line 39:
 | G38.2 G38.3 | Standard probe commands implemented as documented [[http://​linuxcnc.org/​docs/​2.6/​html/​gcode/​gcode.html#​sec:​G38-probe|here]] | <​kbd>​G38.2 Z-10</​kbd>​| | G38.2 G38.3 | Standard probe commands implemented as documented [[http://​linuxcnc.org/​docs/​2.6/​html/​gcode/​gcode.html#​sec:​G38-probe|here]] | <​kbd>​G38.2 Z-10</​kbd>​|
 | G53,​[[G54]]-G59.3 | use workspace coordinates http://​linuxcnc.org/​docs/​html/​gcode/​coordinates.html and http://​linuxcnc.org/​docs/​html/​gcode/​g-code.html#​gcode:​g54-g59.3 | <​kbd>​G54</​kbd>​ | | G53,​[[G54]]-G59.3 | use workspace coordinates http://​linuxcnc.org/​docs/​html/​gcode/​coordinates.html and http://​linuxcnc.org/​docs/​html/​gcode/​g-code.html#​gcode:​g54-g59.3 | <​kbd>​G54</​kbd>​ |
-| [[G90]] | Absolute mode ( //​default// ​) : passed coordinates will be considered absolute ( relative to 0.0.0 ) (command is modal)| <​kbd>​G90</​kbd>​ | +| [[G90]] | Absolute mode ( //default// ) (command is modal)| <​kbd>​G90</​kbd>​ | 
-| [[G91]] | Relative mode : passed coordinates will be considered relative to the current point (command is modal)| <​kbd>​G91</​kbd>​ |+| [[G91]] | Relative mode (command is modal)| <​kbd>​G91</​kbd>​ |
 | [[G92]] | Set global workspace coordinate system to specified coordinates http://​linuxcnc.org/​docs/​html/​gcode/​g-code.html#​gcode:​g92 | <​kbd>​G92 X0 Y0 Z0</​kbd>​ | | [[G92]] | Set global workspace coordinate system to specified coordinates http://​linuxcnc.org/​docs/​html/​gcode/​g-code.html#​gcode:​g92 | <​kbd>​G92 X0 Y0 Z0</​kbd>​ |
 | G92.1 | Clear the G92 and G30 Znnn offsets | <​kbd>​G92.1</​kbd>​| | G92.1 | Clear the G92 and G30 Znnn offsets | <​kbd>​G92.1</​kbd>​|