Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Last revision Both sides next revision
m3 [2017/01/25 18:26]
arthur
m3 [2017/01/25 18:35]
arthur
Line 7: Line 7:
 A spindle is a controlled motor that turns a tool ( endmill ) at a given speed to allow it to remove material from the workpiece. A spindle is a controlled motor that turns a tool ( endmill ) at a given speed to allow it to remove material from the workpiece.
  
-The M3 command must be accompanied by a {{S}} parameter which sets the speed of rotation.+The M3 command must be accompanied by a <kbd>S</​kbd> ​parameter which sets the speed of rotation.
  
-M3's evil twin is the [[[M5]]] command which turns the spindle off ( it is equivalent to {{M3 S0}} ).+M3's evil twin is the [[M5]] command which turns the spindle off ( it is equivalent to <kbd>M3 S0</​kbd> ​).
  
 === Format === Format
Line 24: Line 24:
  
 ||~ Parameter ||~ Usage ||~ Example || ||~ Parameter ||~ Usage ||~ Example ||
-|| {{S}} || The spindle must turn at this speed in rotations per minute || M3 S1000 ||+|| <kbd>S</​kbd> ​|| The spindle must turn at this speed in rotations per minute || M3 S1000 ||
  
 === Configuration === Configuration