Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
fr_cnc-mill-guide [2017/01/25 18:26]
arthur
fr_cnc-mill-guide [2017/01/25 18:37]
arthur
Line 39: Line 39:
 It includes :  It includes : 
 * A special CNC version of the [[http://​smoothieware.org/​panel|Panel]] screens * A special CNC version of the [[http://​smoothieware.org/​panel|Panel]] screens
-{{grbl_mode}} enabled by default+<kbd>grbl_mode</​kbd> ​enabled by default
 * The Spindle module * The Spindle module
  
Line 70: Line 70:
 === Drilling canning cycles === Drilling canning cycles
  
-Smoothie now supports drilling canning cycles, using the [[[drillingcycles | Drillingcycles module]]]+Smoothie now supports drilling canning cycles, using the [[drillingcycles | Drillingcycles module]]
  
 However, if you do not want to use the module, there are solutions to convert those into "​normal"​ G-codes :  However, if you do not want to use the module, there are solutions to convert those into "​normal"​ G-codes : 
Line 84: Line 84:
 == Troubleshooting == Troubleshooting
  
-If you run into trouble, something doesn'​t work as it should, head over to the [[[Troubleshooting]]] page for a list of common problems and means of diagnosis.+If you run into trouble, something doesn'​t work as it should, head over to the [[Troubleshooting]] page for a list of common problems and means of diagnosis.
  
 You can also contact the [[http://​smoothieware.org/​irc|Community]] for help if you can't find an answer in the documentation. You can also contact the [[http://​smoothieware.org/​irc|Community]] for help if you can't find an answer in the documentation.
Line 133: Line 133:
  
 == Testing == Testing
-You should be able to connect and issue [[[supported-g-codes | Gcode commands]]] to your CNC mill with Pronterface. This'​ll allow you to jog your motors and see whether you've wired and configured everything correctly+You should be able to connect and issue [[supported-g-codes | Gcode commands]] to your CNC mill with Pronterface. This'​ll allow you to jog your motors and see whether you've wired and configured everything correctly
  
 == Software ​ == Software ​
  
 {{page>​software}} {{page>​software}}