Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
filament-detector [2019/06/23 19:12]
90.155.91.76 [Configuration options] Fixed table layout (headings were previously misaligned)
filament-detector [2019/08/11 11:11]
wolfmanjm [Filament detector]
Line 8: Line 8:
  
 If a difference is detected, the filament is not advancing correctly, which means that there is a problem with the pushing of the filament. If a difference is detected, the filament is not advancing correctly, which means that there is a problem with the pushing of the filament.
 +
 +**NOTE** smoothie uses the host command ''​action:​pause''​ to tell the host to stop sending gcode. Currently **ONLY** octoprint, pronterface,​ smoopi and printing from sdcard support this.
  
 Use **M404** command to set filament detector parameters: S seconds per check, P pulses per mm Use **M404** command to set filament detector parameters: S seconds per check, P pulses per mm