Differences
This shows you the differences between two versions of the page.
Both sides previous revision
Previous revision
Next revision
|
Previous revision
|
extruder [2018/02/01 16:01] 146.90.249.33 [G-code] |
extruder [2021/01/08 15:57] (current) |
* <kbd>M82</kbd> : Set absolute mode for extruder only | * <kbd>M82</kbd> : Set absolute mode for extruder only |
* <kbd>M83</kbd> : Set relative mode for extruder only | * <kbd>M83</kbd> : Set relative mode for extruder only |
* <kbd>M84</kbd> : Turn the active stepper motor driver's on | * <kbd>M84</kbd> : Turn off stepper motor drivers |
* <kbd>M92</kbd> : Set this axis' steps per millimetre. For example <kbd>M92 E100</kbd> to set for the currently active Extruder, or <kbd>T1 M92 E100</kbd> to set for the second extruder. | * <kbd>M92</kbd> : Set this axis' steps per millimetre. For example <kbd>M92 E100</kbd> to set for the currently active Extruder, or <kbd>T1 M92 E100</kbd> to set for the second extruder. |
* <kbd>M114</kbd> : Displays XYZ position, as well as the E position of the currently active Extruder | * <kbd>M114</kbd> : Displays XYZ position, as well as the E position of the currently active Extruder |