Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
endstops [2018/09/10 13:46]
51.6.19.46
endstops [2019/05/13 23:02] (current)
wolfmanjm [Soft endstops]
Line 130: Line 130:
 Soft(ware) endstops is a feature that allows the board to refuse any command that would put it outside the bounds of the work area. Soft(ware) endstops is a feature that allows the board to refuse any command that would put it outside the bounds of the work area.
  
-Note that this feature only functions once the machine has been homed ( until then it can't know where it is ). After the machine has been homed this feature ​needs to be enabled using the <​kbd>​M211 ​S1</​kbd>​ M-code, and can be disabled ​using the <​kbd>​M211 ​S0</​kbd>​ M-code.+Note that this feature only functions once the machine has been homed ( until then it can't know where it is ). After the machine has been homed this feature ​is enabled. it can be temporarily disabled ​using the <​kbd>​M211 ​S0</​kbd>​ M-code, and can be enabled again using the <​kbd>​M211 ​S1</​kbd>​ M-code.
  
 The configuration is as such :  The configuration is as such :